Livezi Bravo H-DIG-18, Руководство по установке и пусконаладке

Страница: 38 / 56

38
5.6 Zone Touchpads
The zone touchpads house the zone sensors and must be mounted
within the area controlled by the corresponding motorised damper.
The ideal position is 1.5 m off the floor in the return air path. Care
must be taken to avoid solar radiation, wall cavity drafts and other
heat sources.
The LCD zone touchpads allow the user to adjust various aspects of the indoor climate. By
default access to all control functions is available from all LCD touchpads.
Access to some control functions from individual touchpads may be limited via hardware DIP switch
settings during installation. These DIP switches are located on the back of each LCD zone
touchpad.
If access to a function has been limited the LCD touchpad will respond with a beep only.
Connect LCD Touchpad DIP switch functions
Function Description
DIP switch position
1 2 3 4
Factory
Default
The factory default allows full access to
all controller functions. No screen change
when backlighting goes off.
OFF OFF OFF OFF
My Zone
Lock
Access setpoint and clock functions for this
zone only. No access to other zones.
ON OFF OFF OFF
My Zone
Return
Full access. Display defaults to this zone
when backlighting goes off.
OFF ON OFF OFF
Setpoint
Limit
Full access with setpoint range limited to
20 - 25 °C for this zone touchpad.
OFF OFF ON OFF
Mode
Lock
Full access excluding mode changes which
are disabled from this zone touchpad.
OFF OFF OFF ON
Summary
Return
Full access. Display returns to summary
screen when backlighting goes off.
ON ON OFF OFF
5.7 Motorised Dampers
The motorised barrel dampers must all have the same motor type,
and should be fitted in line in the flexible duct.
5.8 Serial Interface
Livezi provides a choice between RS485 and RS232 with the HAB protocol.
5.9 Chatterbox
The Livezi HVAC Chatterbox provides a human machine interface from any browser enabled
device.