LiteOn NA130 845PE Series, Руководство пользователя, Страница: 74 / 84

2. Installing Serial ATA drive
(1) No jumper configuration is required for the
Serial
ATA hard
drive. For more information, refer to the manual that came with
your hard drive.
(2) Install all of the hard drives into the hard drive bays of your
system, including their power cables.
(3) Attach
Serial
ATA data cable to each hard drive. Then attach the
other ends of the cables to one of the Serial ATA150 ports on the
mainboard. All of the connectors are keyed so they will only
attach one way.
Note
The onboard SATA150 controller is a PCI Plug-n-Play (PnP)
device. No changes are necessary in the Motherboard CMOS
Setup for resources or drive types in most applications.
5-2 Installing the Drivers
You must install the appropriate SATA150 driver for your current operating
system. Instructions are given below. If you are re-installing an operating system
see the manual listed below for the instructions and procedures.
Important
If you wish to include your current bootable Serial or Parallel
ATA drive using the Windows NT 4.x, Windows 2000, or
Windows XP operating system onto the onboard SATA150
Controller.
You MUST install the SATA Windows NT4, 2000, or XP
driver software first onto this drive while it is still attached to
your existing hard drive controller.
74