LiteOn NA130 845PE Series, Руководство пользователя, Страница: 17 / 84

7. Close the computer chassis’s cover and reconnect the power cord to the
power supply.
8. Power up the computer, if necessary, setup BIOS utility of expansion card
form BIOS.
9. Install related driver form the operating system.
2-5 Jumpers, Connectors, Headers and Indicators
Inside the case of any computer there are several cables and jumpers that have to
be connected. These cables and jumpers are usually connected one-by-one to
connectors located on the board. During the installation you have to pay attention
to the orientation of the connectors, headers and the cables. Always locate the
position of the first pin on the connector.
This section will show you all of the connectors, headers and indicators, and how
to connect them. Please read the entire section for necessary information before
attempting to finish all the hardware installation inside the computer. A complete
layout diagram is shown in this manual for all the position of connectors and
headers on the board that you may refer to.
Warning
Before proceeding with the installation. Turn the power supply
off (fully turn the +5V standby power off), or disconnect the
power cord before you install or unplug any connectors or
add-on cards. Failing to do so may cause the mainboard
components or add-on cards to malfunction or damaged.
17