Size:
The HDD size based on Mega Byte.
Cylinder:
The total number of cylinders of the hard disk.
Head:
The total number of the read / write heads of
the hard disk.
Wpcom:
Write precom. Ranging from 0 to the
maximum of 65536.
Sectors:
The total number of the sectors defined on the
hard disk.
Note
A new IDE HDD must be first formatted, otherwise it can not
read/write. The basic step in using a HDD is to make a HDD
low-level format, then run FDISK, and then FORMAT the drive.
Most current HDDs have already been subjected to low-level
format at the factory, so you can probably skip this operation.
Remember though, the primary IDE HDD must have its
partition set to active within the FDISK procedure. If you are
using an old HDD that is already formatted, auto detection can
detect the correct parameters. You may need to do a low-level
format or set the parameters manually, and then check if the
HDD is working.
40
Содержание NA130 845PE Series
Страница 10: ...1 2 Layout Diagram 10...
Страница 33: ...4 J36 Chassis speaker out header Mono Pin 1 Speaker power Pin 2 Speaker power Pin 3 NC Pin 4 Speaker control 33...
Страница 83: ...NTOE 83...
Страница 84: ...NTOE 84...