Lister Petter T Series, Руководство оператора

Страница: 29 / 81

28
T series enGines operaTors' handbook
preparing the engine for
storage
1.Replace the fuel in the tank with a
small supply of suitable inhibition
fluid.
2.Drain the lubricating oil from the
sump and refill with new oil.
3.Run the engine for a period to
circulate the oil through the system
and to ensure the inhibition fluid is
passed through the fuel pumps and
injectors.
4.Stop the engine and drain the
lubricating oil from the sump.
The crankshaft should noT be turned
until the engine is again required for
service. The inhibition fluid should be
left in the fuel system.
5.Seal all openings on the engine with
tape.
6.Remove the batteries and store
them fully charged after coating the
terminals with petroleum jelly.
7.Grease all external bright metal parts
and the speed control linkage.
8.Tie labels on the engine clearly
stating what steps have been taken
to inhibit the engine during storage.
returning the engine to
service
1.Refer to the appropriate sections for
the relevant detailed instructions as
necessary to complete this work.
2.Remove the tie-on labels and all the
protective coverings from openings
and apertures.
3.Fill the fuel tank.
4.Refill the lubricating-oil sump with
new oil of the correct specification
and viscosity.
5.Remove the batteries from store. I f
they are still fully charged reconnect
them to the engine.
6.Coat the terminals with petroleum
jelly.
7.Start the engine and check for fuel
and oil leaks before applying load.