Liquivision kaon, Руководство пользователя

Страница: 67 / 107

Dive Computer
User Manual
Liquivision Products, Inc -
67
- Revision 1.9 Software 1.17
Entering the water
We recommend that you turn your KAON on yourself before you enter the water to check the
remaining battery power and to make sure that all is functioning properly. You can turn it on by
tapping the unit in the Down direction 3/5 times.
Turning Your KAON On
Otherwise, it will turn on automatically few seconds after you take it deeper than 1.6 meters / 5.25 feet.
When you start to descend and go below 1.6 meters / 5.25 feet, your KAON will turn into dive mode.
Beginning Your Dive
Dive Display
There are two underwater display layouts – Standard and Graphical. Both look the same while diving
within the No Decompression Limit, but they look different if you enter into decompression.
You can edit the colors of all the items on your screen, although you should be careful to consider how
the changes you make will impact battery consumption. Refer to the
Colors menu item for more
information on setting colors, and to the Important Information About KAON Batteries for impact of
color on power consumption.
The large yellow number in the upper-right-hand corner of your display (here, circled in red) is the
Dive Time. Dive time is measured in seconds, starting from the moment your KAON reaches 1.6
meters / 5.25 feet. It will stop once you surface, and it will reset once you have been on the surface for
more than the
Dive Time
Minimum Surface Interval .
Diving within NDL Limit STANDARD – in DECO GRAPHIC – in DECO
The minutes of your dive can be displayed as follows (refer to the “
Show Hours ” section for details):
•
minutes:seconds, e.g. 135:00
•
hours:minutes:seconds, e.g. 2:15:00
The seconds of your dive can be displayed as follows (refer to the “ Analog Clock ” section for details):
•
as a number, e.g. 135:00
•
a graphical indication of the seconds elapsed: a bar display filling up to a full minute