Dive Computer
User Manual
Liquivision Products, Inc
-
51
-
Revision 1.9 Software 1.17
WARNING
ALWAYS dive base on sufficient gas remaining, NOT No Decompression Limit time remaining
i.e. the amount of time you can dive with no decompression (your No Decompression Limit, NDL)
Your KAON only provides decompression information
or, if you exceed your NDL, the KAON will tell you your decompression plan
It is not connected to your tank in any way and does not provide any information about air-time
remaining. You must use your submersible pressure gauge (SPG) to monitor the gas level remaining in
your tank, and you should always ensure you have sufficient gas to complete your dive safely.
Your KAON does NOT provide information on “air-time remaining”
This may occur BEFORE your No Decompression Limit runs out.
You should ALWAYS begin your ascent so you have sufficient gas to complete your dive
WARNING
NEVER undergo a decompression dive without proper training
NEVER EXCEED the KAON’s No Decompression Limit unless you have training in decompression
diving.
ALWAYS have a backup source of decompression information
Do not rely on the KAON as your definite or single source of decompression information.
Both the KAON Dive Planning and In-Water Decompression Calculations likely still have bugs. We
have looked for them and tried to eliminate them, but they can still appear during use. Bugs can cause
the unit to provide inaccurate or incomplete information, or cause the unit to reset or turn off and stop
providing any information at all.
You should always check for software updates
and install all applicable updates, every time you prepare to use the KAON.
You must have a plan to handle a KAON dive computer failure during your dive. Do not risk your life
by using only one source of information during your dive.
