Liquivision kaon, Руководство пользователя

Страница: 27 / 107

Dive Computer
User Manual
Liquivision Products, Inc -
27
- Revision 1.9 Software 1.17
WARNING
ALWAYS dive base on sufficient gas remaining, NOT No Decompression Limit time remaining
i.e. the amount of time you can dive with no decompression (your No Decompression Limit, NDL)
Your KAON only provides decompression information
or, if you exceed your NDL, the KAON will tell you your decompression plan
It is not connected to your tank in any way and does not provide any information about air-time
remaining. You must use your submersible pressure gauge (SPG) to monitor the gas level remaining in
your tank, and you should always ensure you have sufficient gas to complete your dive safely.
Your KAON does NOT provide information on “air-time remaining”
This may occur BEFORE your No Decompression Limit runs out.
You should ALWAYS begin your ascent so you have sufficient gas to complete your dive
Tec Mode
In Tec mode, the KAON allows up to three nitrox gas mixes, each from 21%-100% oxygen. The first
mix will be your Dive Gas, the second and third will be Deco Gas 1 and Deco Gas 2.
Tec Mode uses the same basic model. Preset gradient factors control the overall decompression
calculations but no reduction factors are applied during the surface interval. Using Tec Mode for
repetitive recreational diving will yield more aggressive NDL’s after short surface intervals reducing
dive safety. Divers should use the mode best suited for their intended dives.
In this mode the KAON assumes you are planning to incur some decompression obligation and gives
you control over a number of extra settings, such as your level of
Conservatism , your Dive PO2 and
Deco PO2 levels, and the depth of your Last Deco Stop (please see the relevant sections of the Dive
Setup menu for mode information). You will also have the option to setup and review your Runtime .
Please note that when you switch from Rec mode to Tec mode for the first
time, you will be prompted to enter your desired level of conservatism with
this “Warning” screenshot. Tap Left to exit this screen.
You can edit your conservatism by going to “Dive Setup > Conservatism”
menu item. The default setting is “2”. For more information on levels of
conservatism, please review the “
Conservatism ” section of the “ Dive Setup ”
portion of this manual.