![background image](http://html1.mh-extra.com/html/linn/majik/majik_service-manual_1925487021.webp)
Page 5.621
REVISION 14: MAJIK and WAKONDA
Sept 95
Copyright © 1995 by Linn Products Limited. All Rights Reserved.
8.
Take the RCU module and separate the two parts carefully as
shown.
9..
Take the part of the RCU with the buttons.
10..
Place it face down over the facia
interim plate.
Check the operation of the
buttons.
11.
Fit the other half of the RCU onto the assembly.
Take care that the ten-pin plug
and socket are aligned prop-
erly. Secure with three screws.
The re-assembly is the reverse of the strip, (step 2 & 1), except for the
connections.
Connect the RCU to the Sneaky module as follows:
Sneaky Receiver:
1. Connect 'Main' on RCU to 'Internal RCU OUT' on Sneaky module.
2. Connect 'Ext' on RCU to 'Internal RCU Return' on Sneaky module.
Sneaky Driver:
Connect ‘MAIN’ on RCU to ‘Internal RCU Out’ on Sneaky Receiver
Links:
Sneaky Receiver: Remove all 4 links at P5.
Sneaky Driver:
No links changes required.
Secure in place
using three
stand-offs.
INSTALLING THE KNEKT RCU/S CONTROL PANEL