![background image](http://html1.mh-extra.com/html/linn/majik/majik_service-manual_1925487014.webp)
Page 5.614
REVISION 14: MAJIK and WAKONDA
Sept 95
Copyright © 1995 by Linn Products Limited. All Rights Reserved.
LINN KUDOS SNEAKY MODULE UPGRADE IN LINN MAJIK / WAKONDA
P
HOTO
4
P
HOTO
3
6.
Fit the KUDOS tuner PCB into the MAJIK/WAKONDA :-
(i) Align the mounting plate in the Sneaky slot aperture,
(ii) Align the two white
plastic stand- offs in their
holes,
(iii) Apply a steady even
pressure on top of the
extension connector and
near the plastic stand-offs
to push the KUDOS tuner
PCB into position. (See
photo 3). Try and keep
t h e b o a r d h o r i z o n t a l
whilst pushing into posi-
tion.
Excessive force is not
required.
7.
Fit two M3 screws with shake-proof washers to hold the mounting plate into
the Sneaky slot. The shake-proof washers MUST be used to ensure
electrical grounding. Check with Multi-meter (set to Ohms) for continuity
between earth pin of mains plug and top of screening can on Kudos board.
8.
Remove the facia assembly from the MAJIK / WAKONDA :-
(i)
Unplug the display ribbon cable and the power-on LED connector,
(ii)
Remove the two facia screws underneath and the two counter
sunk screws at each end, then lift off the facia.
9.
Now working on the facia assembly, remove the four screws and take off
the MAJIK / WAKONDA control PCB.
10.
Lift off the grey rubber
switch membrane.
11.
Snap off the four legs
along on the back of the
display window along
with the rivet washers.
(See photo 4)
12.
Push off the MAJIK /
WAKONDA display win-
dow along with the con-
trol buttons.
13.
Remove the four screws and lift-off the MAJIK / WAKONDA control area
mounting plate.
14.
Fit the new KUDOS control area mounting plate, which has extra holes for
the additional buttons, using the existing screws. Ensure the two in-fill
mouldings which are located under the mounting plate are correctly
positioned. (New screws are included for use if required.)