Page 5.615
REVISION 14: MAJIK and WAKONDA
Sept 95
Copyright © 1995 by Linn Products Limited. All Rights Reserved.
P
HOTO
5
15.
Fit the new 11-buttons assembly by engaging the return hooks first to
ensure they are not damaged, and then fit the new window to hold the
buttons to the control area plate and push firmly into place. Ensure the
protective film can
be easily removed,
and is not trapped
behind the window.
16.
Turn the facia over,
fit the display leg-
ends label (check it
i s t h e r i g h t w a y
around!) over the lo-
cating pins and rivet
in place by pushing
the push-on rivet
washers HARD into
place on the pins using a 5 mm Nut-runner.
(See photo 5)
17.
Fit one of the long ribbon cables to the KUDOS control PCB. Both the cables
are same, but the end are handed differently. Fit the cable with the end that
enables the cable to point directly downwards.
18.
Fit the KUDOS control board to the facia with three M3 screws removed
previously. A nylon insulating bush MUST be fitted under the top screw to
prevent a short-circuit to the adjacent track. (New screws are included for
use if required, as is an additional insulating bush.)
19.
Ensure all the buttons are functioning properly and clicking audibly, then
refit the facia assembly to the MAJIK/WAKONDA using the two counter-
sunk screws at the ends and the two screws underneath which were
removed earlier.
20.
Re-fit the power-on LED connector to the MAJIK / WAKONDA main PCB.
Plug the ribbon cable
from the KUDOS con-
trol PCB into the fur-
thest connector (P6) on
the KUDOS main PCB.
Plug the second long
ribbon cable into the
other connector (P5) on
the KUDOS main PCB
using the end which
makes the cable face
forwards, and then plug
the other end into the
connector (P8) on the
M A J I K / W A K O N D A
main PCB.
(See photo 6)
If the cables are correctly fitted they will cross-over each other. Incorrect
connection will not cause any damage, but the control panel will not
operate.
P
HOTO
6
P8
P6
P5
LINN KUDOS SNEAKY MODULE UPGRADE IN LINN MAJIK / WAKONDA
