Page 5.604
REVISION 14: MAJIK and WAKONDA
Sept 95
Copyright © 1995 by Linn Products Limited. All Rights Reserved.
INTRODUCTION
INTRODUCTION
Both the Linn MAJIK control amplifier and WAKONDA pre- amplifier use
microprocessor control, Linn’s solid state input switching and volume
control technology, and the latest surface mount manufacturing techniques
to deliver unprecedented audio performance and ease of use.
They accommodate six input sources, and provide outputs for two tape
decks. You may record any source while listening to the same or any other
source. For the purposes of this manual, the Majik and Wakonda are the
same, unless otherwise stated, except when refering to the POWER- AMP
section, which is only fitted to the MAJIK
Separate pre-amp output and power amp inputs (MAJIK ONLY) provide
exceptional flexibility, and offer the possibility of a neat and economical
upgrade to active systems. Two sets of speaker sockets facilitate bi-wiring.
Options include multi-room modules and a tuner which simply plugs into the
internal expansion port known as the "Sneaky" slot.
Like any electronic product, the MAJIK and WAKONDA will perform at their
best when used with the highest quality source. The better the sound from
your turntable, tuner or CD player, the better the sound you will hear from
the other components in the system.
INSTALLATION
Unpack the product and retain the packing for future transportation.
Check the contents are as follows:
MAJIK or WAKONDA
Remote handset
Owner's manual
Mains lead
1 spare fuse.
VOLTAGE SELECTION - MAJIK
This is factory set for a 240 Volts mains supply and must not be
connected to a mains supply before it is adjusted for the local
voltage, and fitted with the appropriate fuse.
To set the voltage, rotate the voltage selector on the underside
of the product until the appropriate voltage is aligned with the
white marker.
To fit the fuse, first identify the correct fuse for the local
voltage
MAJIK
3.15A anti-surge for 220V and 240V,
6.3A anti-surge for 100V and 120V.
VOLTAGE SELECTION - WAKONDA
As the WAKONDA is fitted with a Brilliant switched mode power supply,
voltage selection is automatic.
Fuse: WAKONDA T500 mA for all input voltages (90-264 V AC)
Pull open the fuse-drawer at the left-hand side of the mains inlet, insert
the fuse in the rear compartment and close the drawer.
IMPORTANT NOTE FOR UK USE: The wires in this mains lead use the
following colour code:
Green-and-yellow:
Earth
Blue:
Neutral
Brown:
Live
As the colours of the wires in the mains lead of this appliance may not
correspond with the coloured markings identifying the terminals in your plug,
proceed as follows:
The wire which is coloured green-and-yellow must be connected to the
terminal in the plug which is marked with the letter E, or by the earth symbol
or coloured green or green-and-yellow.
