![background image](http://html1.mh-extra.com/html/linn/majik/majik_service-manual_1925487020.webp)
Page 5.620
REVISION 14: MAJIK and WAKONDA
Sept 95
Copyright © 1995 by Linn Products Limited. All Rights Reserved.
4.
Fit the new interim plate into the facia, and secure with four
screws.
5.
Assemble the buttons to the window.
No display label is required.
7.
Check that all the buttons are hooked through
the plate properly.
Secure the window in place by pressing on
the four clips using the Linn tool.
Plastic in-fill pieces
should be left in place.
Bring the facia
down at an angle
and insert the
c l i p s i n t o t h e
holes in the plate.
Then tilt the facia down
over the window.
6.
Place the facia over the top with the method shown below:
INSTALLING THE KNEKT RCU/S CONTROL PANEL
FACIA