![background image](http://html1.mh-extra.com/html/linn/majik/majik_service-manual_1925487018.webp)
Page 5.618
REVISION 14: MAJIK and WAKONDA
Sept 95
Copyright © 1995 by Linn Products Limited. All Rights Reserved.
5.
Push the extension connector into
the holes on the underside of the
KNEKT board.
It is important to fit this connector first
to the KNEKT board and not to the
MAJIK / WAKONDA board, otherwise the
pins may be damaged on assembly.
6.
Lower the Sneaky board on to the pillars.
7.
Align the header connector and socket
on the MAJIK/WAKONDA.
8.
Press down the header connec-
tor and socket on the MAJIK/
WAKONDA.
9.
Press down the header on the SNEAKY board fully into the socket on
the MAJIK/WAKONDA board.
10.
Replace the two screws on to the SNEAKY slot and tighten in place.
11.
Change configuration if required. (See Knektips.doc on RCU Instal
Disc).
13.
Replace the sleeve including the 4 screws.
INSTALLING SNEAKY KNEKT MODULE IN THE MAJIK / WAKONDA