![background image](http://html.mh-extra.com/html/linksys/rtp300-broadband-router-with-2-phone-ports/rtp300-broadband-router-with-2-phone-ports_administration-manual_1923888096.webp)
Linksys ATA Administration Guide
96
Info page
Message Waiting
Indicates whether you have new voice mail waiting. Options are either Yes or
No. The value automatically is set to Yes when a message is received. You also
can clear or set the flag manually. Setting this value to Yes can activate
stutter tone and VMWI signal. This parameter is stored in long term memory
and survives after reboot or power cycle.
Call Back Active
Indicates whether a call back request is in progress. Options are either Yes or
No.
Last Called Number
The last number called from the FXO Line.
Last Caller Number
Number of the last caller.
Mapped SIP Port
Port number of the SIP port mapped by NAT.
Call 1 and 2 State
May take one of the following values:
•
Idle
•
Collecting PSTN Pin
•
Invalid PSTN PIN
•
PSTN Caller Accepted
•
Connected to PSTN
Call 1 and 2 Tone
Type of tone used by the call.
Call 1 and 2 Encoder
Codec used for encoding.
Call 1 and 2 Decoder
Codec used for decoding.
Call 1 and 2 FAX
Status of the fax pass-through mode.
Call 1 and 2 Type
Direction of the call. May take one of the following values:
•
PSTN Gateway Call = VoIP-To-PSTN Call
•
VoIP Gateway Call = PSTN-To-VoIP Call
•
PSTN To Line 1 = PSTN call ring through and answered by Line 1
•
Line 1 Forward to PSTN Gateway = VoIP calls Line 1 then forwarded to
PSTN GW
•
Line 1 Forward to PSTN Number =VoIP calls Line 1 then forwarded to
PSTN number
•
Line 1 To PSTN Gateway
•
Line 1 Fallback To PSTN Gateway
Call 1 and 2 Remote
Hold
Indicates whether the far end has placed the call on hold.
Call 1 and 2 Callback
Indicates whether the call was triggered by a call back request.
Call 1 and 2 Peer Name
Name of the internal phone.
Call 1 and 2 Peer Phone
Phone number of the internal phone.
Call 1 and 2 Call
Duration
Duration of the call.
Call 1 and 2 Packets
Sent
Number of packets sent.
Call 1 and 2 Packets
Recv
Number of packets received.
Call 1 and 2 Bytes Sent
Number of bytes sent.
Call 1 and 2 Bytes Recv
Number of bytes received.
Call 1 and 2 Decode
Latency
Number of milliseconds for decoder latency.