Linksys ATA Administration Guide
127
Line page
SIP Debug Option
SIP messages are received at or sent from the proxy listen port. This
feature controls which SIP messages to log. Choices are as follows:
•
none
—No logging.
•
1-line
—Logs the start-line only for all messages.
•
1-line excl. OPT
—Logs the start-line only for all messages except
OPTIONS requests/responses.
•
1-line excl. NTFY
—Logs the start-line only for all messages except
NOTIFY requests/responses.
•
1
-line excl. REG
—Logs the start-line only for all messages except
REGISTER requests/responses.
•
1-line excl. OPT|NTFY|REG
—Logs the start-line only for all messages
except OPTIONS, NOTIFY, and REGISTER
requests/responses.
•
full
—Logs all SIP messages in full text.
•
full excl. OPT
—Logs all SIP messages in full text except OPTIONS
requests/responses.
•
full excl. NTFY
—Logs all SIP messages in full text except NOTIFY
requests/responses.
•
full excl. REG
—Logs all SIP messages in full text except REGISTER
requests/responses.
•
full excl. OPT|NTFY|REG
—Logs all SIP messages in full text except for
OPTIONS, NOTIFY, and REGISTER requests/responses.
The default is none.
RTP Log Intvl
The interval for the RTP log.
Restrict Source IP
If Lines 1 and 2 use the same SIP Port value and the Restrict Source IP feature
is enabled, the proxy IP address for Lines 1 and 2 is treated as an acceptable
IP address for both lines. To enable the Restrict Source IP feature, select yes.
Otherwise, select no. If configured, the PAP2T will drop all packets sent to its
SIP Ports originated from an untrusted IP address. A source IP address is
untrusted if it does not match any of the IP addresses resolved from the
configured
Proxy
(or
Outbound Proxy
if
Use Outbound Proxy
is yes).
The default is
no
.
Referor Bye Delay
Controls when the ATA device sends BYE to terminate stale call legs upon
completion of call transfers. Multiple delay settings (Referor, Refer Target,
Referee, and Refer-To Target) are configured on this screen. For the Referor
Bye Delay, enter the appropriate period of time in seconds.
The default is
4
.
Refer Target Bye
Delay
For the Refer Target Bye Delay, enter the appropriate period of time in
seconds.
The default is
0
.
Referee Bye Delay
For the Referee Bye Delay, enter the appropriate period of time in seconds.
The default is
0
.
Refer-To Target
Contact
To contact the refer-to target, select yes. Otherwise, select no.
The default is
no
.
Sticky 183
If this feature is enabled, the IP telephony ignores further 180 SIP responses
after receiving the first 183 SIP response for an outbound INVITE. To enable
this feature, select yes. Otherwise, select no.
The default is
no
.