Lightware UMX-HDMI-140, Руководство пользователя

Страница: 151 / 161

11. Appendix UMX-HDMI-140 series– User's Manual 151
Applied firmware package: v1.3.0b5 | LDC software: v2.5.6b2
Available Stop bits ............................................................................................................................... 1 / 1.5 / 2
Infrared
Number of IR ports ....................................................................................................................2 (1x RX, 1x TX)
Input connector type ........................................................................................
3.5 mm TRS (approx. 1/8" jack)
Output connector type ....................................................................................... 3.5 mm TS (approx. 1/8" jack)
Input carrier frequency ............................................................................................................................. 38 kHz
Output signal ........................................................................ modulated (38kHz) / not modulated (baseband)
Ethernet
Connector type .................................................................................................................. Locking RJ45 female
Ethernet data rate .......................................................................... 10/100Base-T, full duplex with autodetect
Power over Ethernet (PoE) ..........................................................................................................Not supported
GPIO
Connector type .......................................................................................................... 8-pole Phoenix connector
Number of configurable pins ............................................................................................................................ 7
Port direction............................................................................................................................... Input or output
Input voltage: Low level / Max. current ................................................................................................. 0 - 0,8 V
Input voltage: High level / Max. current .................................................................................................... 2 - 5 V
Output voltage: Low level ....................................................................................................................... 0 - 0,5 V
Output voltage: High level ...................................................................................................................... 4.5 - 5 V
Max. current: Low level .............................................................................................................................. 30mA
Max. current: High level ............................................................................................................................. 18mA
Total available current ............................................................................................................................ 180 mA
11.2. Content of Backup File
The backup file contains numerous settings and parameters saved from the device. When the file is uploaded
to a device, the followings will be overwritten:
Analog video input ports (VGA, DVI-A)
Horizontal position, Vertical position, Active horizontal size, Active vertical size, Total horizontal size, Pixel
phase
Test pattern mode, Test pattern resolution, Test pattern color
Digital video input ports (HDMI, DP, DVI-D)
Video port name, Audio port name, HDCP setting
Test pattern mode, Test pattern resolution, Test pattern color
HDMI output port
Port name, HDCP mode, HDMI mode, Power +5V mode, Color space setting
Analog audio input ports
Port name, Volume, Balance
Crosspoint settings
Video crosspoint settings, audio crosspoint settings
Autoselect (enable/disable, delay settings, priority list)
Mute/lock state of video ports, Mute/lock state of audio ports
Serial port
RS-232 mode, Control protocol, Baud rate, Data bits, Stop bits, Parity
Port name and Command Injection (CI) port number
IR port
Port status (enable / disable), Code length, Repetition code, Modulation state
Input port name, Output port name
CI status (enable / disable), CI port number
Network settings
DHCP status (enable / disable), Static IP address, Network mask, Gateway address
Further settings
Device label
User presets (1-32), User EDID data (U1-U15), Event manager: settings of all Events
GPIO port configuration (pin 1-7)
  
