Lightware UCX-2x1-HC30, Руководство пользователя

Страница: 18 / 167

3. Front Panel Control UCX series – User's Manual 18
Applied firmware package: v1.2.0b9 | LDC software: v2.5.10b1
3.1.3.2. Factory Default By Pressing AUDIO OUT button
DIFFERENCE: This function is available from 1.2.0 firmware package. #new
To restore factory default values, do the following steps:
Step 1.
Make sure the device is powered on and operational.
Step 2.
Press and keep pressed the
AUDIO OUT
button for 10 seconds.
Step 3.
After 5 seconds front panel LEDs start blinking but keep on pressing the button.
Step 4.
After 10 seconds the LEDs start blinking faster; release the button and press it 3 times again quickly
(within 3 seconds).
Step 5.
The LEDs get dark, the device restores the factory default settings and reboots.
Factory default settings are listed in the Factory Default Settings section.
3.1.4. Control Lock
Press the
VIDEO OUT1 ( VIDEO OUT1 (
VIDEO IN1
in in
UCX-2x1-HC30 model
) )
and
AUDIO OUT
buttons
together
(within 100 ms)
to disable/enable front panel buttons; front panel LEDs blink 4 times when locking/unlocking. If the control
lock is enabled and a button is pressed, front panel LEDs blink 3 times quickly.
AUDIO
OUT OUT 2
HDMI
INPUT SELECT
OUT1
VIDEO
AUDIO
OUT OUT 2 OUT 1
VIDEO
INPUT SELECT
RESET
10
sec
AUDIO
OUT OUT 2
HDMI
INPUT SELECT
OUT1
VIDEO
AUDIO
OUT OUT 2 OUT 1
VIDEO
INPUT SELECT
3x
AUDIO
OUT OUT 2
HDMI
IN 4
INPUT SELECT
OUT1
VIDEO
AUDIO
OUT OUT 2 OUT 1
VIDEO
INPUT SELECT
3.2. Status LEDs
INFO: When Dark mode is enabled, no LEDs are lit, even though the device is fully functional. For more
details about the dark mode see Status section.
3.2.1. Front Panel LEDs
Arrangement of the status LEDs #status
3.2.2. Rear Panel LEDs
USB Status
Video Input Status
USB Status
Video Input Status
Video Input Status LED (the upper one)
off There is no valid video signal on this port.
on There is a valid video signal on this port.
blinks once The port is selected by a button press.
USB Status LED (the below one)
off No USB Host or deselected port.
on USB Host connected and selected.
Video Output Status
off The signal is not present or muted.
on The video signal is present.
   