3. Front Panel Control
UCX series – User's Manual
17
Applied firmware package: v1.2.0b9 | LDC software: v2.5.10b1
3.1.2.
Enable DHCP IP Address
DIFFERENCE:
This function is available from 1.2.0 firmware package.
#new
The device has a dynamic IP address as a factory default setting. If this setting does not fit to the
circumstances during install or usage, DHCP can be enabled from the front panel:
Step 1.
Make sure the device is powered on and operational.
Step 2.
Press and keep pressed the
AUDIO OUT
button for 5 seconds.
Step 3.
After 5 seconds front panel LEDs start blinking; release the button and press it 3 times again quickly
(within 3 seconds).
Step 4.
The LEDs get dark, DHCP gets enabled.
#dhcp
3.1.3.
Reset to Factory Default Settings
There are two ways to restore the factory defaults:
#factory
3.1.3.1.
Factory Default By Pressing VIDEO OUT 2 (VIDEO IN2) Button
To restore factory default values, do the following steps:
Step 1.
Make sure the switcher is powered off.
Step 2.
Power on the switcher while the
VIDEO OUT2
(
VIDEO IN2
in UCX-2x1-HC30 model) is being pressed for
10 seconds. The device restores the factory default settings and reboots.
AUDIO
OUT
OUT 2
HDMI
INPUT SELECT
OUT1
VIDEO
AUDIO
OUT
OUT 2
OUT 1
VIDEO
INPUT SELECT
RESET
5
sec
AUDIO
OUT
OUT 2
HDMI
INPUT SELECT
OUT1
VIDEO
AUDIO
OUT
OUT 2
OUT 1
VIDEO
INPUT SELECT
3x
3.1.
Button Functionality
INFO:
If the control lock is enabled and a button is pressed, front panel LEDs blink 3 times quickly.
3.1.1.
Video Source Selection
UCX-2x1-HC30
Use
IN1
and
IN2
buttons for selecting the video source.
IN1
button
switches the USB-C IN1 to the output,
IN2
button switches the HDMI IN2
to the output.
Use AUDIO OUT button for selecting the audio source of the analog audio
output.
The sequence is the following (for the audio switching):
UCX-2x2-H30
Use
OUT1
and
OUT2
buttons for selecting the video source. Push
OUT1
to
select the video input for the HDMI OUT1 port,
OUT2
button switches the
video input for the HDMI OUT2 port.
Use
AUDIO OUT
button for selecting the audio source of the analog audio
output.
The sequence is the following (both for the video and audio switching):
UCX-4x2-HC30 and UCX-4x2-HC30D
Push
OUT1
to select the video input for the HDMI OUT1 port.
Push
OUT2
to select the video input for the HDMI OUT2 port.
Push AUDIO OUT to set the audio source of the analog audio output.
The sequence is the following (both for the video and audio switching):
#switch #crosspoint
1
USB-C IN 1
2
HDMI IN 2
1
HDMI IN 1
2
HDMI IN 2
1
USB-C IN 1
2
USB-C IN 2
3
HDMI IN 3
4
HDMI IN 4