LGMG SR1018D, Руководство по эксплуатации

Страница: 11 / 109

Elevating Work Platform Operation Manual
4
2) The safety decal should be cleaned with
mild soap and water.
3) Do not use solvent-based cleaners as they
may damage the material of the safety
label.
1.6 Risk of Electric Shock
1) This machine is not insulated and is not
provided with electrical shock protection
when it comes into contact with or near
electrical wire.
2) This machine should be kept an adequate
safety distance from power line and
electrical equipment according to
applicable government laws and
regulations and the following table.
Voltage
Required safety
distance
0V-50 KV 3.05m/10ft
50 KV-200 KV 4.60m/15ft
200 KV-350 KV 6.10m/20ft
350 KV-500 KV 7.62m/25ft
500 KV-750 KV 10.67m/35ft
750 KV-1,000 KV 13.72m/45ft
3) The effects of strong winds or gusts on the
movement of the platform, the swinging and
slackening of the wires should be
considered.
4) If the machine comes into contact with live
wires, keep away from the vehicle. No one
is allowed to touch or operate the vehicle
on the ground or platform before cutting off
the power supply.
5) Do not operate the machine when there is
lightning or storms.
6) Do not use the machine as a ground wire
during welding.
1.7 Safety of Work Area
1) The platform can only be raised on a solid
and flat level ground.
2) The speed shall not exceed 1.1 km/h when
the platform is raised.
3) The tilt alarm cannot be regarded as level
indicator. When the machine is seriously
inclined, the tilt alarm of the chassis and
platform will ring.
4) If tilt alarm sounds, lower the platform and
move the machine to solid level ground. If
the tilt alarm rings when the platform is
raised, the platform shall be lowered very
carefully.
5) Do not operate the machine in strong winds
or gusts. The surface area of the platform
or load cannot be increased. Increasing the
area exposed to the wind will reduce the
stability of the machine.
6) If the machine is used outdoors, do not
elevate the platform when wind speed is
above 12.5 m/s. If wind speed exceeds the
limit after elevating the platform,
immediately lower the platform and stop all
machine operation.
7) In the elevated state of the platform, the
machine cannot run on uneven terrain, an
unstable surface, or in other dangerous
situations, or near these areas.