LGMG SR1018D, Руководство по эксплуатации

Страница: 100 / 109

Elevating Work Platform Operation Manual
93
9.1 No Operation is Allowed
Unless
You have understood and practiced the
principles about safe operation of the vehicle in
this manual.
1) Avoid dangerous situations.
2) Always perform a pre-operation inspection.
3) Check the workplace.
4) Always perform a pre-use functional test.
5) Use the vehicle only for its intended
purpose.
9.2 Basic Principles
1) The machine is a rough terrain hydraulic lift
equipped with work platform on a scissors
mechanism. Vibration produced by the
operation of machine has no danger to the
operator on the work platform. The machine
can carry staff and portable tools to the
place in a certain height from the ground, or
to the working area on the machine or
equipment.
2) The Operating Instructions section provides
specific instructions for all aspects of
vehicle operation. It is the operator’s
responsibility to follow all safety rules and
instructions in this manual.
3) This machine is designed for lifting workers
and tools to the overhead workplace, it is
unsafe or even dangerous to use the
vehicle for other purposes.
△
!
Notice: This machine is strictly
prohibited from carrying loads.
4) Only trained and authorized personnel can
operate the vehicle. If more than one
operator uses the same vehicle at different
times during the same work shift, they must
be qualified operators and follow all safety
rules and instructions in the Operation and
Maintenance Manual. This means that
every new operator should perform
pre-operation inspections, functional tests
and workplace inspections before operating
the machine.
9.3 Emergency Stop
1) On the Ground Control Station or Platform
Control Station, push the red emergency
stop button to "Off" position to close all
functions and shut down the engine.
2) If there is any functions operating after
pushing the red emergency shutdown
button, repair the function.
9.4 Engine startup
1) On the Ground Control Station, turn the key
switch to the needed position.
2) Make sure that the ground and platform red
emergency stop buttons are pulled out to
"On" position.
3) Press the engine startup button.
△
!
Notice: Before starting the engine
at 10
℃
and lower temperatures, press
and hold the glow plug for 5 to 10
seconds. The continuous use of the
glow plug is limited to 20 seconds.
△
!
Notice: SR1023D/SR1323D/
SR1623D engine(For Deutz D2.9L4-EU
Ⅴ
) can be automatically preheated at
low temperatures. The engine can be
preheated only when the whole vehicle
is powered on.
If the primary startup time is no more than 5 - 10
seconds (continuous working time of starter
motor shall be no more than 15 seconds), and if
it fails to be started and needs to be started
again, the interval shall be more than 1 minute.
If it fails to be started for three times, identify the
reason and repair the fault. Wait for 60 seconds
before attempting to start it again.
At -6
℃
and lower, idle the engine for 5 minutes
before operation to the engine is lubricated fully
and prevent damage to the hydraulic system.
At extremely low temperatures of -18
℃
and
lower, the machine must be equipped with a
low-temperature starter kit option. If the engine