LGL Electronics SPIN1, Инструкция по эксплуатации

Страница: 56 / 60

56
6.1.4 System Error display
An “E” followed by an error code appears in the icon area on the display
unit as in the example provided below:
These system errors are useful to LGL technicians. In cases when such
Error Codes appear on the display unit, please contact LGL Customer
Service. The alarm LED does not blink and the Spin unit continues running.
Please consider that, in these cases, the general warning icon (a triangle
with an exclamation mark) will not appear on the screen.
6.1.5 Special icons
Please contact LGL Customer Service in cases when the following icons
appear in the icon side bar.
6.2 ALARMS
Alarm states are always signalled by the SPIN unit by causing the orange
Leds to blink and by sending a stop signal to the machine.
6.2.1 Weaving Alarms
These alarms can be reset by pressing the “X” button or directly from the
machine (via INC/DEC interface or serial communication).
With these alarms ON, the SPIN unit continues supplying yarn for about 5
metres and then switches off the motor.
−
“OverFeed”
: Yarn Overfeed Error. It is actuated when the SPIN unit reads
on the cell a yarn tension that exceeds the desired value but cannot
adjust the yarn tension, though turning at the maximum speed. Ensure
the yarn does not slip on the feeding wheel. Possibly add one or two coils.
−
“TensError”
: Tension Error. It is actuated when the measured tension
exceeds the limit values set in the “TE-TensionError” parameter, and
only if the “TA-Time Alarm” parameter is other than “OFF” (See chapters
4.2.3 and 4.2.4).
6 - MESSAGES AND ALARMS
System Error
Code