LGL Electronics SPIN1, Инструкция по эксплуатации

Страница: 50 / 60

50
4.2.13.1 “DeviceIDsetting”
ID = SPIN identification address. It is needed by the SPIN for serial commu-
nication with the outside world.
This value can be set from 1 to 254.
This address is automatically set by the SPIN if connected to the LGL box or
to the flat cable terminal clamp with included numbers. In this case, the ID
cannot be manually edited via the “Device ID setting”. Hence, it will remain
set to “
OFF
”.
In installations where the ID data is not set from the outside (on the system),
the above-mentioned menu can be accessed and the desired address can
be assigned by means of the “+” and “-” buttons.
Please note that if no external address is provided and neither has it been
assigned manually, the communication will be inhibited and the related
warning message will appear on the display unit accordingly (see chapter 4.1
dealing with the “SETUP MENU” page).
The default value, when no external address is provided, is “OFF”.
Remember that, once the device ID has been manually assigned, you
need to switch the unit OFF and then back ON to validate the actuation
of the serial communication.
By simultaneously pressing the “+” and “-” buttons the increase Step value is
set. The increase value will alternatively change from 01 to 10.
By holding pressed the “X” button for 3 seconds, the minimum value that the
parameter can take is set.
4.2.13.2 “RS485 BaudRate”
RS485 Serial Line communication speed.
01 = 38400 bauds (default)
02 = 9600 bauds
By holding pressed the “X” button for 3 seconds, the minimum value that the
parameter can take is set.
4 - SETTING THE OPERATING PARAMETERS