25
206-4292 Draft A.2
Express Script (Cont.)
(Continued from previous page)
1. In the Pro:Centric Mode
fi
eld, use the Left/Right arrow keys on the Installer Remote to select the
appropriate Pro:Centric Application Mode—FLASH, GEM, HTML, or CONFIGURATION ONLY.
Note:
For remote management only, select
CONFIGURATION ONLY
. The TV will search for
TV E-Z Installation data downloads; however, Pro:Centric application data will not be downloaded,
i.e., Installer Menu item 098 PRO:CENTRIC will be set to 0.
2. Refer to the appropriate subsection below, depending on the Pro:Centric server con
fi
guration, to
complete the remaining
fi
elds.
RF Con
fi
guration
a) In the Media Type
fi
eld, use the Left/Right arrow keys on the Installer Remote to select
RF
.
b) In the Data Channel
fi
eld, use the Left/Right arrow keys to select the RF channel number
that will be used by the Pro:Centric server as its data channel. The Data Channel value can
be set from 1 to 135.
*
IP Con
fi
guration
a) In the Media Type
fi
eld, use the Left/Right arrow keys on the Installer Remote to select
IP
.
Note:
When you select “IP” as the Media Type, the default RF Data Channel
fi
eld is replaced
with IP Input Type, IP Address, and IP Port
fi
elds.
b) The IP Input Type
fi
eld provides the option to specify the domain name of the Pro:Centric
server instead of the server’s IP address and port number. Use the Left/Right arrow keys to
select the desired option—NUMBER or DOMAIN—for de
fi
ning the server.
c) Depending on your selection in the previous step, either:
• Enter the Pro:Centric server IP address and port number in the IP Address and IP Port
fi
elds, respectively. The IP address must match the IPv4 multicast address and the port
number must match the port number that is set in the Pro:Centric server.
• Enter the Pro:Centric server domain name in the Domain Name
fi
eld. Note that in order
for the domain name to be resolved to an IP address, there must be a DNS entry for the
domain name.
For each data entry
fi
eld: Use the arrow keys to select the
fi
eld and press
OK
. Then, you
can either use the number keys on the Installer Remote to direct enter data values, or you
can use the arrow keys to select the appropriate number(s)/alphanumeric character(s) from
the pop-up virtual keyboard displayed at the bottom of the screen. When you are done, select
Enter
from the virtual keyboard, and then press
OK
on the Installer Remote.
3. Once all
fi
elds are completed as required, you have two options:
• To proceed with TV con
fi
guration via the Express Script, select
NEXT
and press
OK
on the
Installer Remote. Continue to “Complete the TV Con
fi
guration” on the following page.
• To save the data entered and exit the Express Script, use the arrow keys to select
DONE
and
then press
OK
on the Installer Remote. Remember, however, that if you do not complete the
Express Script, pillow speaker functionality will not be enabled unless you set Installer Menu
item 027 HOSPITAL MODE appropriately. See the “Installer Menu” section of this document
for further information.
*
PCS150R and later Pro:Centric servers do not support HRC or IRC cable channel frequencies.
