Lexmark T63 Series, Руководство по обслуживанию

Страница: 63 / 345

Diagnostic information
2-29
4060- xxx
59 Incompatible Tray x An incompatible tray is installed. For Tray x , x = 2, 3, 4,
or 5.
Remove the incompatible tray and press
Go to clear
the message.
Note: If the user installed the incompatible device to
satisfy a Check Device Connections/reattach
message, the user should reinstall an associated
compatible option or hot unplug the option.
59 Incompatible Duplex An incompatible duplex option is installed.
Remove the incompatible duplex option and press
Go
to clear the message.
Note: If the user installed the incompatible device to
satisfy a Check Device Connections/reattach
message, the user should reinstall an associated
compatible option or hot unplug the option.
61 Defective Disk This error code displays when the printer detects a
defective disk. This error may occur at power on or
during disk format and write operations. While this
message displays, press
Go to clear the message.
The disk is marked defective and normal printer
operations continue. Disk operations are not allowed
with a defective disk. The Format Disk menu is not
shown.
62 Disk Full This error code displays when there is not enough free
space on the disk to hold the resources that have been
requested to be written to the disk. This message
displays for both resource and PostScript Disk
operators when the disk is full.
63 Unformatted Disk This error code displays when the printer detects an
unformatted disk at power on. Press
Go to clear the
message. The disk is marked as bad and normal
operation continues. Disk operations are not allowed
until the disk is formatted.
64 Unsupported Disk
Format The printer detects an unsupported disk format at
POR.
Press
Go to clear the message. The disk is marked as
bad and normal operation continues. Further disk
operations are not allowed until the disk is formatted.
80 Scheduled
Maintenance The operator panel displays this message at each
300K page count interval. It is necessary to replace the
fuser assembly, transfer roller, charge roll, and pick
rolls at this interval to maintain the print quality and
reliability of the printer. The parts are available as a
maintenance kit. For more information, go to
“Scheduled maintenance” on page 6-1 .
81 Engine Code CRC
Failure This error displays when the microcode to be
programmed in the engine flash code module has
failed a CRC check. Press
Go to clear the message.
The microcode data is discarded and must be re-
transmitted from the host computer.
88 Toner Low This message displays when toner low occurs and the
toner low alarm is activated. Press
Go to clear this
message.
User attendance messages (continued)
Primary message Secondary message Explanation