Lexmark T63 Series, Руководство по обслуживанию

Страница: 146 / 345

3-18
Service Manual
4060- xxx
Setting configuration ID
The configuration ID is used to communicate information about certain areas of the printer that
cannot be determined using hardware sensors. The configuration ID is originally set at the factory
when the printer is manufactured, however it requires resetting whenever you replace the
interconnect board and can be set on the operator panel. However the configuration ID is the only
diagnostic function displayed until a valid ID is entered.
To set the configuration ID:
1.
Enter the Diagnostic mode.
2.
Select Configuration ID from the Printer Setup menu.
3.
At the prompt, enter the model name and serial number for your printer.
4.
Enter the configuration ID.
•
The current ID displays on the screen. The Configuration ID is on a label located inside the
printer. The label is attached to the top front cover hinge assembly and is visible when the
top front cover is open.
•
The leftmost digit blinks indicating that it is the first digit to be changed.
5.
To change the value, press Menu until the value you want is reached. Press Select to move to
the next digit, or press Select again to skip a digit. Change each digit as required. When the last
digit is changed, press Select to validate the Configuration ID. If the ID is invalid then “INVALID
ID” message displays on Line 2 before the ID displays. You have to reenter the Configuration ID
until a valid ID is verified. If the ID is valid then the ID is saved in NVRAM and the printer
automatically PORs to activate the new setting.
Note: When the printer PORs it does so in the normal mode.
Restore EP Factory Defaults
To restore each of the printer settings contained in the EP Setup menu to their factory default value
select
Restore from the menu. To exit the menu without restoring the settings to the factory default
values, select Do Not Restore . Sometimes this is used to help correct print quality problems.
Fuser Temperature
This adjustment can be used to help solve some customer problems with paper curl on low grade
papers and problems with letterheads on some types of media.
The fuser temperature can be adjusted to: NORMAL, LOWER, LOWEST
Warm Up Time
You can change the amount of time the printer warms up before allowing pages to print by changing
this setting from 0 to 5. The factory sets the warm up at 0 or no warm up time. This time period lets
the backup roll heat up and helps reduce curl in some environments.
Transfer
The transfer can be adjusted to: LOW, MEDIUM, HIGH