Lexmark T63 Series, Руководство по обслуживанию

Страница: 142 / 345

3-14
Service Manual
4060- xxx
5-Bin Mailbox Option
1.
Select Output Bin Tests from the menu.
2.
Select Output Bin tests - Sensor Tests .
3.
Select Sensor Tests for Output Bin x ( x =number of the output option to be tested).
The following screen is displayed:
Output Bin x
P1=OP P2=OP L=NL
P1 =5-Bin Mailbox first pass thru sensor
P2 =5-Bin Mailbox second pass thru sensor
L = EM , 5-Bin x empty
L = NL , bin contains media, but the bin is NOT near full nor full
L = NF , the bin is near full
L = FL , the bin is full
4.
Once the screen is displayed, manually actuate each of the sensors of the high-capacity
stacker, except for the output level sensor. When the sensor is closed,
CL displays, and when
the sensor is open OP displays.
5.
Select Return or Stop to exit the test.
Finisher Tests for StapleSmart Finisher
Finisher Feed Tests
This test is used to verify whether or not media can be fed to a finisher output bin and stapled. No
information is printed on the test pages as the printhead is not turned on. Eight sheets of paper feed
and then the pages staple.
Note: This test can be run using any of the paper sizes supported by the printer.
The media is fed from the selected source and then outputted to the finisher output bin.
To run the StapleSmart Finisher Feed Test:
1.
Select Finisher Tests from the menu.
2.
Select Feed Tests from Finisher Tests menu.
3.
The feed test runs (may take a minute for the test to complete).
Eight sheets of paper feed into the finisher and then are stapled.
Note: This test cannot be stopped until the test is completed.
4.
Select Return/Stop to exit the test.
Finisher Sensor Tests
This test can be used to verify whether or not the finisher sensors are working correctly.
To run the Finisher Sensor Test:
1.
Select Finisher Tests from main menu.
2.
Select Sensor Tests from the Finisher Tests menu.