Lexmark M3150, Руководство по обслуживанию

Страница: 90 / 400

200 paper jams
200 paper jam messages
Notes:
•
Some error messages are applicable only to printer models with a polygon LSU (laser scanning unit).
•
If the sixth digit character assigned to the serial number of the printer is in the P–Z range, then the
printer is installed with a polygon LSU (example: 4514 2ZHH 007CR).
Error code Description Action
200.01 Input sensor covered during warm-up sequence. Go to “Sensor (input) static jam service check”
on page 92 .
200.02 Input sensor covered too quickly. Go to “Sensor (input) early/late arriving service
check” on page 92 .
200.03 Page did not reach input sensor or was late
reaching input sensor, but was successfully
picked from the source. Go to “Sensor (input) early/late arriving service
check” on page 92 .
200.05 Input sensor covered too long. Source = [x]. Go to “Sensor (input) early/late arriving service
check” on page 92 .
200.08 Page arrive at input senor at unexpected time. Go to “Sensor (input) early/late arriving service
check” on page 92 .
200.09 Printhead did not receive proper motor feedback
to start laser servo. Go to “Sensor (input) image jam service check”
on page 94 .
200.10 Printhead motor not locked when media reaches
the input sensor. Go to “Sensor (input) image jam service check”
on page 94 .
200.11 Printhead motor fell out of lock after page reaches
the input sensor. Go to “Sensor (input) image jam service check”
on page 94 .
Mirror motor got locked, and then lost it again
before the initial lock timeout. Go to “Laser scanning unit (LSU) service check”
on page 136 .
200.12 Printhead was not ready for media. Go to “Sensor (input) image jam service check”
on page 94 .
200.13 Media at input sensor is not the next media to be
imaged. Go to “Sensor (input) image jam service check”
on page 94 .
200.14 Media reached the input sensor before EP was
ready. Go to “Sensor (input) image jam service check”
on page 94 .
200.15 Input sensor covered too long. Source = [x]. Go to “Sensor (input) early/late arriving service
check” on page 92 .
200.16 Fuser motor stalled. Go to “Main drive motor control jam service
check” on page 95 .
200.21 No response from paper port driver while waiting
for the source to deactivate the Input Source
Ready flag to indicate it has initiated picking. Go to “Sensor (input) early/late arriving service
check” on page 92 .
200.23 Laser servo never started due to potential conflict
with the transfer servo. Go to “Sensor (input) image jam service check”
on page 94 .
4514-6xx
Diagnostics and troubleshooting
90