26
3.
Route the Ethernet wire across the charging
station from right to left between the auxiliary
power supply and the contactor assembly. Zip
tie the Ethernet wire to the existing cable
bundle at each corner (c).
4.
Route the Ethernet wire down behind the
touchscreen adjustment bar.
5.
With hand pressure, swing the bottom of the
touchscreen out to a 45 degree angle (d).
6.
Re-measure the distance to the “Ethernet” port
of the Station Management Unit (e) and trim
excess wire.
Important:
The bottom edge and corners of
the touchscreen are sharp. Take care when
moving underneath the raised screen.
250_IGcombo.pdf 32
11/18/2019 3:37:41 PM