IES-0880 User Manual
Page 92
BRIDGE-FORWARD Puts all ports of the specified bridge into the forwarding state.
8.
Example:
The following example enables or disables the
spanning-tree
on bridge GROUP (
1
):
switch_a(config)#bridge 1 spanning-tree enable
switch_a(config)#no bridge 1 spanning-tree enable bridge-forward
switch_a(config)#
Bridge Priority (0..61440):
1.
Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The
switch_a(config)#
prompt will show on the screen.
switch_a(config)#
2.
Usage:
Use this command to set bridge priority for the common instance. Using a lower priority
indicates a greater likelihood of the bridge becoming root.
3.
Command Syntax:
bridge GROUP priority PRIORITY
no bridge GROUP priority
GROUP <1-1> The ID of the bridge group for which the priority is set.
PRIORITY <0-61440> The bridge priority.
4.
Example:
The following example sets the
priority
PRIORITY (
4096
) of bridge GROUP (
1
):
switch_a(config)#bridge 1 priority 4096
switch_a(config)#
Hello Time (sec) (1..9):
1.
Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The
switch_a(config)#
prompt will show on the screen.
switch_a(config)#
2.
Usage:
Use this command to set the hello-time, the time in seconds after which (if this bridge is
the root bridge) all the bridges in a bridged LAN exchange Bridge Protocol Data Units
(BPDUs).
3.
Command Syntax:
bridge GROUP hello-time HELLOTIME
no bridge GROUP hello-time
