IES-0880 User Manual
Page 101
lower value implies a better priority. In the case of the same priority, the interface index
will serve as the tiebreaker, with the lower-numbered interface being preferred over
others. The permitted range is 0-240. The priority values can only be set in increments of
16.
3.
Command Syntax:
bridge GROUP instance INSTANCE_ID priority PRIORITY
GROUP <1-1> Specify the bridge-group ID.
INSTANCE_ID <1-15> Specify the instance ID.
PRIORITY <0-240> Specify the port priority in a range of <0-240>.
4.
Example:
The following example sets the port priority (
121
) for Multiple Spanning Tree instance (
3
)
to a port (
fe1
) in bridge GROUP (
1
):
switch_a(config)#interface fe1
switch_a(config-if )#bridge-group 1 instance 3 priority 121
switch_a(config-if )#
Bridge-Group Instance Path-Cost:
1.
Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The
switch_a(config-if)#
prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if )#
2.
Usage:
Use this command to set the cost of a path associated with an interface. Use the no
parameter with this command to restore the default cost value of the path. A lower path-
cost indicates a greater likelihood of the specific interface becoming a root.
3.
Command Syntax:
bridge GROUP instance INSTANCE_ID path-cost PATH_COST
GROUP <1-1> Specify the bridge-group ID.
INSTANCE_ID <1-15> Specify the instance ID.
PATH_COST <1-200000000> Specify the cost of path in the range of <1-200000000>.
4.
Example:
The following example sets the path cost (
1000
) for Multiple Spanning Tree instance (
3
) to
a port (
fe1
) in bridge GROUP (
1
):
switch_a(config)#interface fe1
switch_a(config-if )#bridge-group 1 instance 3 path-cost 1000
switch_a(config-if )#
