Levante NEW BINGO 2017, Руководство по эксплуатации и техническому обслуживанию

Страница: 12 / 32

LEVANTE s.r.l.
Via dell’Economia 10 – 46035 Ostiglia MN Italia
VAT NO. and TAX CODE 01730440201 Reg. of Comp. of MN no. 01730440201 Share Cap. fully paid-up €20,800.00 Economic and Administrative Index
No. 178082
Tel. +39 0386 801814 Fax. +39 0386 801955
e-mail: commerciale@levantelift.it
NEWBINGO 2017-operating and mainspare parts v.02072017
12
3. Operating procedures
The stacker must be used in compliance with the current safety regulations and accident prevention regulations in
chapter 2.
Before using the forklift, perform the preliminary checks described in par. 6.1.
3.1 Preliminary checks
Before using the stacker, check the points listed in the table.
OPERATION FREQUENCY PROCEDURES
Check the status of belts, wheels, mast, side
handles
Daily Visual inspection
Check the correct rolling of the wheels Daily
Move the forklift forward/backward and
right/left
Check the locking of the wheel stop Daily
Activate the wheel stop and ensure that the
forklift does not move by trying to move it
Check the operation of the loads
ascent/descent lever
Daily
Move the lever up and ensure the forks lift
Move the lever down and ensure the forks
lower
Check the operation of the emergency stop
device
Daily
During ascent, switch the emergency key
ensuring it locks the forks movement
3.2 Loading
Balance the load adequately so that the load centre is inside the forks of the machine. Do not overload the forklift
beyond the rated capacity and never place the load on a single fork.
Only use pallets in good condition and avoid the load from protruding beyond the pallet itself.
Do not use the forklift to lift suspended loads or loads able to freely swing, nor to lift or transport people. Always
check the load condition during use of the forklift. If the load becomes unstable, stop use and restore stability before
continuing.
3.3 Forklift handling
The forks are lifted via electric command located on the operator console. The forklift is manually handled, by pushing
or pulling, by acting on the appropriate handles. Move the forklift slowly and steadily, keeping the load lowered.
During loading, the command circuits of the forks are disabled.
The forks lowering function is inactive with the key in the OFF position.
ATTENTION: The forklift is not suitable for continuous use, the actuator may be damaged. For every minute of
use of the lifter, leave the motor in stand-by for one minute.
During handling operations keep your hands, feet or other body parts away from the lifting mechanisms.