LEVANTE s.r.l.
Via dell’Economia 10 – 46035 Ostiglia MN Italia
VAT NO. and TAX CODE 01730440201
Reg. of Comp. of MN no. 01730440201 Share Cap. fully paid-up €20,800.00 Economic and Administrative Index
No. 178082
Tel. +39 0386 801814 Fax. +39 0386 801955
e-mail: [email protected]
NEWBINGO 2017-operating and mainspare parts v.02072017
19
5.
Routine maintenance
A daily check can prevent any damage to your forklift. Particular attention must be dedicated to wheels, rollers, etc,
which may be blocked or damaged by residues on the ground during use.
A three-month inspection is recommended of the parts most subject to wear, such as belt, rollers, wheels, bearings
and pulleys.
If you need any assistance, please contact
LEVANTE S.r.l.
If the user fails to comply with this publication, we are not liable for problems or anomalies on the proper operation of
the supply and on the validity of the warranty stipulated in the contractual phase.
Daily inspection and maintenance
It is necessary to inspect the device daily, in particular to check rollers, axes, so that dust, wires or similar do
not block the rollers during use.
Lubrication
Use motor oil or grease to lubricate all moving parts.
:
DO NOT USE THE FORKLIFT IF MALFUNCTIONS ARE DETECTED
DO NOT ATTEMPT TO REPAIR THE DEVICE WITHOUT HAVING BEEN PROPERLY TRAINED AND AUTHORISED
Below is a list of the inspections and periodic maintenance recommended by LEVANTE.
: Always follow the general warnings in par. 1.6, 1.7 and 1.8.
OPERATION
FREQUENCY
PROCEDURES
SOLUTION
Check fork thickness is greater
than 90% of the original thickness
at the heel
Monthly
Use a gauge
In case of non-compliance,
replace the forks
Check surface cracks of the fork
jib cranes
Monthly
Visual inspection
In case of non-compliance,
replace the forks
Check the height difference
between the tips of the fork jib
cranes and the horizontal length
of the fork jib crane. Value must
be less than 3%.
Monthly
Measure
the
height
difference between the tips
and divide by the length of
the fork jib crane.
In case of non-compliance,
replace the forks
Check the wear of the support
belts of the lifting unit
Quarterly
Visual inspection for:
1.
signs of cracks
2.
wear of fixing
3.
fixing, completeness and
good condition of the
anchoring device
In case of non-compliance,
replace the belts
Lubricate the moving parts (mast,
guides)
Quarterly
Visual inspection
Grease with motor oil or
grease suitable for mechanical
parts
