Leroy-Somer E27 Series, Установка и обслуживание

Страница: 27 / 112

10 / 31
These screws are painted red. Clamp the mobile plates to the casing through the holes found in the
casing. They must be removed following the mechanical installation of the brake. Tightening them
will cause the mechanical release of the brake. They must never be placed in the installation, to avoid
them being accidentally tightened and causing the lift to fall.
Fig. 6
After being removed, it is convenient to place the caps supplied with the brake to avoid the insertion
of particles in the inside of the brake.
If the brake incorporates Bowden release levers (by cable), once the opening
cables have been placed in position, the red fixing screws must be removed
from the handles. If the screws remain tight they could cause the brake to be
released and the lift to fall.
Fig. 7
3.6 Positioning the rubber dust cover:
Position the rubber dust cover before plugging in the electric
connection.
11 / 31
Once the brake has been clamped to the machine place the rubber. The rubber avoids the insertion
of dirt particles in the mobile parts the brake. Precaution: It is not prepared to prevent penetration
by liquids.
Optical detectors must be covered, as they are sensitive to dirt and light.
3.7 Placement of the manual release lever:
Types of lever and their components:

“ Manual Release Lever”:
Fig. 8

“ Bowden Release
” Lever (by cable):
Fig. 9
Both lever models share the same brake assembly process.