Lenovo ThinkServer RS110, Руководство по техническому обслуживанию аппаратной части

Страница: 97 / 252

4. Slide the server into the rack.
5. Reconnect all external cables and the power cord.
6. Turn on all attached devices and the server.
Removing and replacing Optional-service CRUs
You may install a Optional-service CRU yourself or request Lenovo to install it, at
no additional charge, under the type of warranty service that is designated for your
server.
The illustrations in this document might differ slightly from your hardware.
Removing the battery
To remove the battery, complete the following steps:
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 57.
2. Turn off the server and peripheral devices, and disconnect the power cords and
all external cables.
3. Remove the cover (see “Removing the cover” on page 60).
4. If necessary, lift the riser-card assembly out of the way (see “Removing the
riser-card assembly” on page 88).
5. Remove the battery:
a. Use a fingernail to press the top of the battery clip away from the battery.
The battery pops up when released.
b. Use your thumb and index finger to lift the battery from the socket.
6. Dispose of the battery as required by local ordinances or regulations.
See“Battery return program” on page 224 for more information.
Installing the battery
The following notes describe information that you must consider when you replace
the battery in the server.
v
You must replace the battery with a lithium battery of the same type from the
same manufacturer.
v
To order replacement batteries in U.S. and Canada, call Lenovo Service and
Support. Outside the U.S. and Canada, call your Lenovo marketing
representative or authorized reseller.
v After you replace the battery, you must reconfigure the server and reset the
system date and time.
v
To avoid possible danger, read and follow the following safety statement.
Chapter 4. Removing and replacing server components
79