Lenovo ThinkAgile CP, Замена аппаратных компонентов и процедуры технического обслуживания

Страница: 151 / 162

Management switch maintenance procedures (optional)
Procedures for replacing the Lenovo ThinkAgile CP management switch.
Note:
A dedicated out-of-band management switch is required for this solution. If the Lenovo ThinkSystem
NE0152T RackSwitch is not used, you must provide an out-of-band management switch with the correct
configuration. Disregard this procedure if you are not including the Lenovo NE0152T as the management
switch in your solution.
Refer to Chapter 2 “Roles and responsibilities” on page 15 to determine who can perform these procedures.
For information about the terms of the warranty, visit
https://datacentersupport.lenovo.com/us/en/
warrantylookup
.
Replacing the management switch (optional)
This section covers the procedures required to replace an existing management switch.
Note:
A dedicated out-of-band management switch is required for this solution. If the Lenovo ThinkSystem
NE0152T RackSwitch is not used, you must provide an out-of-band management switch with the correct
configuration. Disregard this procedure if you are not including the NE0152T as the management switch in
your solution.
Removing the management switch (optional)
This section describes how to remove the ThinkSystem NE0152T RackSwitch from a standard 19‐inch
equipment rack. For information about removing the switch from other supported racks, see the appropriate
section in this chapter.
Note:
A dedicated out-of-band management switch is required for this solution. If the Lenovo ThinkSystem
NE0152T RackSwitch is not used, you must provide an out-of-band management switch with the correct
configuration. Disregard this procedure if you are not including the NE0152T as the management switch in
your solution.
This section describes how to remove the NE0152T from a standard 19‐inch equipment rack.
Chapter 5
.
Part replacement and maintenance procedures
143