Leitronic AG EA-8-WRL868, Инструкция по использованию

Страница: 25 / 40

25
8. TROUBLE SHOOTING / ERROR HANDLING
Most problems can be checked and solved with help of the following chart. If the problem remains after consul-
ting this chart in details, please get in touch with your local dealer or contact the info line of your country.
8.1 Telephone connection / Telephone communication
Symptoms Cause and /or remedy
LED is not lit after switching ON Replace battery
Announcement „programming
deactivated: PIN“ by an attempt of
reprogramming Programming function is locked => to be unlocked according to
section 5.4.2
Announcement „Beep Beep Beep“
Announcement „battery error”
Mains loss and low battery at the same time!
Battery is low => replace battery
Announcement „power failure” Power failure, transformer not connected
Announcement „line check error “
No dial tones are audible during test call
=> no tones are audible during the
dialling procedure
No dial tone has been detected:

Unit is not connected with the telephone network

Telephone network failure

Another telephone working on the same phone line is occupying
the line already

Plug in telephone cord

Check the telephone cord

Start test-call with different telephone
Test call does not call selected calling
number:
Announcement „calling number
n error“

Calling number n is not programmed => Calling number 1 will
be dialled instead
Test call does not establish phone
connection: Announcement „calling
number n “ => dial tone audible

Calling number is wrong

Called party is not answering the phone
Remote access using dialling-in not
possible =>
EasyAlarm
®
is not
responding to the call

The dialling function is programmed for the two step modus (

section 0)
Remote access using dialling-in not
possible => disconnection after entering
of PIN-code Wrong PIN-code entered => call again
EasyAlarm
®
does not react on tone-
dialling commands
Current telephone does not support tone-dialling commands or has
not been configured => for example pulse dialling
8.2 Acoustical monitoring
Symptom Cause and /or remedy
Noise is not triggering an alarm

Factory setting supports monitoring of acoustics only on pos. III
of selection switch. (programming can be altered

section 5.6)

The unit has been deactivated by DTMF 7 => LED
alternatively 4s on / 4s off

By switching on the unit or after triggering an alarm, the
acoustical monitoring is not active during the
waiting time of 20
seconds (

section 6.4) => LED is lit constantly during the
waiting time !

Depending on the position of the selection switch, an alarm is
triggered with a different delay. Every time the noise exceeds the
pre set level, the LED is on (

section 6.4.1)
8.3 Motion detector (wired sensor 1)
Symptom Cause and / or remedy
LED is on during WALK TEST, but no
alarm is triggered

Active/inactive by switching on the unit or between two alarms
is not expired

Supervision has been temporarily deactivated (deactivation)

Supervision is deactivated at current position of the selection
switch (I/II/III) (

section 5.6)

Motion detection is programmed to verify presence (

section
9.10), an alarm is only triggered if no motion is detected over a
programmed time.

Test mode => check section 10.2.4