Leitronic AG EA-8-WRL868, Инструкция по использованию

Страница: 22 / 40

22
7. USEFUL NOTES
7.1 Tone-dialling command
If you want to use
EasyAlarm
®
to its full potential a tone-dialling telephone is necessary. Nowadays most of
the telephones in use are working on tone dialling, also called DTMF or in-band signalling. Older telephones
are using pulse dialling. In case there is no tone-dialling telephone available, the features shown in section 6.7.3
cannot be used
Note:

An acoustic coupler can be purchased in electronic shops.
7.2 User information
7.2.1 Signals (beeps)
A single beep tone is used as a confirmation.
Three beep: Mains power loss AND battery low at the same time!
7.2.2 Announcement audible in loudspeaker of EasyAlarm®
Announcement Message / Cause
„Individual message“ First message in case of an alarm
Abort Disconnection caused from the change of the position of the selection switch
Alarm acknowledged Disconnection by pressing key 0 or emergency button
Alarm due to fire zone n Alarm triggered by smoke sensor (sensor function 1) on n
Alarm due to sensor n Alarm call due to wired sensor n
Alarm due to technical detector
zone
n
Alarm due to technical detector on zone n
Alarm due to zone n Alarm due to sensor (function 3..7) on zone n
Battery error Battery is low => battery test after power on (function switch from PROG to
ON)
Battery error, zone n Announce if a low battery of wireless sensor (zone n ) is detected
Notes:

If the zone n is a concentrator than one of the learned-in contact
sensors has a low battery status or there is a mains power loss at the
concentrator itself

If there is a mains power loss at the repeater, than the first repeated
zone would also announce low battery status.
Calling number n Calling number n ( n = 1..9)
Calling number sequence Calling number sequence
Detector malfunction, zone n Status report missing at zone n
Emergency call activated Emergency call, initiated by emergency button
Emergency call deactivated,
alarm acknowledged Emergency call confirmed
Error Incorrect programming => the old value remains stored
Line check error Telephone line check after power on was negative => dial tone missing
Output activated Output switch activated
PIN Request to enter PIN-Codes by locked programme
Power failure Mains power missing => Mains power is tested after switching on the unit
Programming deactivated: PIN Request to enter PIN-Code to unlock programming
Supervision (I/II/III) <due to
noise/sensor
n> activated
Announcement of the monitored alarm functions at current position of the
selection switch (I/II/III) triggered by pressing key
5 .
during the inactive
waiting period (

section 6.3.1)
Supervision (I/II/III) activated Announcement in active supervision mode at current position of the selection
switch (I/II/III)
Supervision (I/II/III)
deactivated Announcement deactivated supervision mode at current position of the
selection switch (I/II/III)
Supervision due to sensor
activated Presence verification activated (wired sensor 1)
to modify press *, to stop press
# Recording of individual message
Unacknowledged alarms: n Quantity of unacknowledged alarms
Zone x, y, z, is open The monitor zone stay in active supervision open