Leitronic AG EA-8-WRL868, Инструкция по использованию

Страница: 8 / 40

8
5. PROGRAMMING
Important notes:

All the programmed parameters remain stored even
EasyAlarm
®
is off

You can prevent your system from unintended re-programming according to (

section 5.4.1). If the
programming is locked, when the function switch is on position PROG. Follow by message
„programming deactivated, PIN“ will be announced
5.1 How to program new calling numbers
EasyAlarm
®
supports nine calling numbers that can be programmed as follows:
1. Slide function switch to PROG
2. Enter * * <n> (selected calling number: Standard n = 1..9)

Select number will be announced followed by “to modify press star“
3. If you like to change this calling number, press * , otherwise proceed with step 5
4. Enter new calling number. To delete an existing number enter
*
and proceed with step 5
5. Slide function switch to OFF
Notes:

Every keystroke will be acknowledged by a beep

Key
# .
programmes a dialling delay of 5 seconds, provided it is entered between two digits, e.g. a delay is
essential in a private exchange (first digit +
# .
+ calling number).

If your private exchange needs a flash pulse to start an internal call, following programming is possible:
2 . # .
followed by the extension number.

Key * . is used as separator for Point-ID protocol

section 5.1.1.

If a programming error occurs, put function switch to OFF and repeat point 1 to 5.
Important notes:

Calling number 1 cannot be deleted due to safety reasons.
5.1.1 Point-ID (Contact-ID) alarm protocol
If the alarm should be transferred to a alarm organisation using the Point-ID (Contact-ID) protocol, the alarm
number has to be followed by key
* and the customer-ID. EasyAlarm forwards the protocol to this alarm
number and connects hereafter to the following calling number in standard hands-free connection mode
Alarm number Customer-ID
074567890 34567
Example for programming the calling number:
0 7 4 5 6 7 8 9 0 * 3 4 5 6
.
Note:

The first character
*
, that follows the alarm number will not be transmitted (=> separator). The customer
ID is a four digit code. In case of an alarm the following codes are transmitted according to the <Alarm
reason> and the <Zone> .
Code
<Alarm reason> <Zone>
602 Alarm due to cyclic test 900
602 Alarm due to remote programming "**#" 900
381 Alarm due to radio supervision Radio zone 000..009
301 Alarm due to power failure 900
384 Alarm due to low battery of a radio sensor Radio zone 000..009
102 Alarm due to missing activity (presence verification) Radio zone 000..009
601 Alarm due to key-press (test-call) 900
132 Alarm due to noise monitoring 900
140 Alarm due to hardware sensor 1 901
140 Alarm due to hardware sensor 2 902
140 Alarm due to hardware sensor 3 903
137 Alarm due to radio sensor tamper Radio zone 000..009
140 Alarm due to radio sensor Radio zone 000..009
154 Alarm due to technical detector Radio zone 000..009
120 Alarm due to panic button Radio zone 000..009
120 Alarm due to emergency button Radio zone 000..009
111 Alarm due to fire sensor Radio zone 000..009