Leitronic AG EA-8-WRL868, Инструкция по использованию

Страница: 24 / 40

24
7.4 Battery check / replacement
7.4.1 Alarm unit
If you hear „Battery error“ or three beep after switching on the battery should be replaced immediately as
follows:
1. Slide function switch to OFF
2. Disconnect
EasyAlarm
®
from the telephone network, by removing the telephone cord
3. Open battery compartment and remove old battery
4. Insert new battery and close battery compartment
5. Reconnect telephone cord to
EasyAlarm
®
Notes:

Always use fresh 9V-batteries

Dispose the old battery properly
7.4.2 Sensor
If you hear the announcement „Battery error, zone n “ the battery of the appropriated wireless component
should be replaced immediately as follows. Pay attention to the note here that is special indication for sensor in
question.
Important notes:

If the battery of the telecommand key switch or remote lock is low, please put function switch of the
alarm unit to off, before you try to replace the battery. Otherwise a detected tamper would delete the
zone and you have to do the learning-in again

The announce for low battery on a zone can be because a mains power loss of the repeater or
concentrator => section 5.5.6.1 and
Fehler! Verweisquelle konnte nicht gefunden werden.
7.5 Maintenance
Slide function switch to OFF and remove telephone cord. Clean
EasyAlarm
®
if necessary using a moistened
cloth and dry it afterwards.
Note:

Do not use cleaning agents or solvent