LABvault-SD
System Installation
Page 7
2018-06-08
d. Optional:
the LABvault-SD FTP buffer size setting helps to control the rate at which data is transferred to and
from the LABvault.
The buffer size defaults to 16 kilobytes, but may be adjusted down to 4 KB or up to 64 KB. If
your network equipment can handle a higher rate, edit the setting to 32 or 64 KB for faster transfer times.
To change the FTP buffer size, peform the following:
Network Address Configuration Steps
Corresponding Screen Displays
i.
From the “CONFIG MENU” screen, press “↑” or “↓“ to
proceed to the “Edit FTP TCP Buf” screen.
ii.
Press “→“ to select the screen.
iii.
Press “→“ or “←“ to position the underscore beneath the
editable fields and press “↑“ or “↓“ to edit the values.
iv.
Press “→“ again to apply change and enter reboot
message screen or “←“ to abort changes.
The LABvault-SD must be powered down and then powered back up to apply any FTP buffer size
changes (press the red “X” button for four seconds to turn the unit off and then press the green
check button for two seconds to return power).
CONFIG MENU
Edit FTP TCP Buf
TCP Buf size:
64 kbytes
