1997-2001 FLH Renegade– Rev. 3
8.
See Fig. 4
Install key switch through body.
9.
See Fig. 4
Install latch cable bracket onto key
switch.
10.
See Fig. 4
Install large nut to rear door key
switch using 7/8” wrench and adjust bracket in
an upright position.
11.
See Fig. 4
.Attach cable to key mechanism while
key is in vertical position with head of screw from
cable facing out.
12.
See Fig. 5
. Install striker pin to striker bracket
using 5/16” lock nut .
•
(1) Striker Pin– GL2041
•
(1) Striker Bracket– LB1297
•
(1) 5/16” Lock Nut– CN3045
13. Attach striker pin bracket to door using 1/4”
lock washers and 1/4” bolts .
•
(2) 1/4” x 1/2” Bolts– CB1075
•
(2) 1/4” Lock Washers– CW2040
14. Install Renegade badge to bottom right side
of door. Install Lehman badge GB1320 to
bottom left side of door.
•
(1) Renegade Badge– GB1324
•
(1) Lehman Badge– GB1320
15. Cut license plate wire from body to length to
reach body wiring as needed.
16. Install shrink tubing over license plate wires.
17. Strip and solder ends of license plate wires from the body and door together.
18. Slide shrink tubing over soldered connections and heat.
19. Solder and heat shrink light wiring to trunk wiring harness. Attach wire as follows-
•
Black
wire on light to
Black
wire on trunk harness
•
Red
wire on light to
Red
wire on trunk harness
20. Secure wiring to trunk door.
30
Fig. 5
Striker pin
and bracket
Fig. 4
Key switch
Cable bracket
