1997-2001 FLH Renegade– Rev. 3
20
Installing Lehman Frame and
1.
See Figs. 1-3
. Install frame plates to H-D frame with (2)
5/16” X 1 1/2” bolts, flat washers (if necessary, between
frame plate and motorcycle frame) and lock nuts for
front hole only. Rear bolt will be used with imitation
fender. Do not tighten bolts.
Note: See Fig. 1. Front bolt on each side will install
from inside with head of bolt toward middle of trike.
This provides clearance between fender and bolt.
2. Set frame in place and install (2) 1/2” X 1 1/2” bolts, flat
washers and lock washers, through front holes of trike
frame and into original shock mount on H-D frame.
3.
See Fig. 2 and 3.
Attach frame plates (LB1220) to Leh-
man frame plate using 5/16” X 1” bolts, flat washers and a
lock nuts
.
4.
See Fig. 2
. Level Lehman frame to H-D frame. Frames
should be parallel with each other. Tighten all bolts when
level. Torque front 1/2” bolts to
78 ft.-lbs.
Torque all
frame plate bolts to
19 ft. lbs.
5.
See
Fig. 3.
Lower differential and install 1/2” X 2 1/4”
bottom shock bolt through lower shock eye and thread it
into shock plate. Use (1) washer under head of bolt.
Torque bolt to
40 ft.-lbs.
and secure bolt with lock nut.
Note: Do not install flat washer under lock nut.
6.
See
Fig. 3.
Raise differential and install top of shock using 1/2” X 2 1/4” bolt, lock washers and (1)
washer under head of bolt. Shock should run parallel to frame tube when viewed from rear. Torque
shock bolts to
40 ft.-lbs.
Fig. 2
Fig. 1
Front bolt on each side
Rear bolt on each side
Fig. 3
Level frame
Frame plate
