Legacy Super Magnum Coal Stoker, Инструкция по установке и эксплуатации

Страница: 24 / 47

FOR YOUR SAFETY- At 17 to 21 feet of duct length, the 1/2 inch tab
MUST be removed from the top of the plate. At 21 feet or more, the
cover plate can remain solid, allowing all of the heated air to flow
through the duct pipe.
Do not connect this appliance to the supply duct of an existing
furnace. This option is intended for use with a single heat register.
4.5 AIR FILTER
To ensure cleanliness of the air circulated through the heat
exchange, the Super Magnum is equipped with a replaceable filter.
The filter is located under the stove. To remove the filter, loosen the
two thumb screws and remove the cover. Slide the filter out the open
slots in the front of the channel. Check the filter for damage, change
if necessary. Replacement filters can be obtained through your
Legacy Stoves
TM
dealer, or from most hardware, or building supply
centers. Be sure to turn the blower off prior to changing.
4.6 OPTIONAL DECORATIVE TILE KIT
1. To install the optional ash door tile, you'll first need to
disassemble the ash door.
2. Lay the ash door, face down, on a flat workspace.
3. Remove the four screws which hold the filler plate into the
door.
4. Lay the filler plate and screws aside, and lay the tile into
place on the door assuring that the tile is centered on the
gasket.
5. Apply the self adhesive gasket onto the back side of the tile.
6. With the filler plate flipped over from its original position,
it now becomes the backer for the tile. Attach using the
four screws.
-24-