Legacy Super Magnum Coal Stoker, Инструкция по установке и эксплуатации

Страница: 23 / 47

4.2 OUTSIDE AIR ATTACHMENT
Parts and Supplies Needed: 1 piece of metal flexible pipe, 3" X
needed length. 1 Rodent Screen, Plus, you'll want to obtain a trim
ring for finishing around the pipe on the inside wall.
1. Remove the knockout from the bottom shield. There are
three small areas that are not previously cut. You can cut
these tabs using a hacksaw or by drilling them. A small
rounded file will be helpful in removing any sharp burrs from
the cut.
2. Determine an appropriate hole location, through the wall. Be
sure there are no studs or other supporting members. Also
ensure there are no electrical wires or plumbing contained
within the wall.
3. Make the hole through the exterior wall using a hole saw or
reciprocating saw. You'll want the hole to be just slightly
larger than the metal flex pipe.
4. Attach the rodent screen to one end of the flex pipe, and
insert it through the wall until the back of the screen cover is
against the outside surface.
5. Hold the flex pipe in place to make an accurate
determination of the length needed. Cut the flex pipe to
length.
6. Slide the trim ring onto the flex for the inside wall portion.
7. Slide the other end of the metal intake flex pipe through the
bottom shield and secure it to the shield with a minimum of
two screws. The flex pipe does not make a positive
connection to the appliance, it will supply outside air as a
proximity source.
8. Secure the trim ring in place for finishing the inside wall area.
9. Seal around the rodent screen on the exterior wall, using silicone caulking.
4.3 LEVELING THE APPLIANCE
To adjust the leveling bolts, you must first loosen the locking nut.
Turn the leveling bolt to the desired position, and re-tighten the
locking nut against the cast iron leg.
4.4 OPTIONAL HEAT TRANSFER KIT
The duct piping must be of metal construction in accordance with
NFPA 90B, 2-1.1, and 2-1.3.
1. Lift and remove the round cover from the top of the Super
Magnum.
2. Install the 6" duct pipe starting collar into the round opening.
Reaching down through the starting collar, bend the tabs
upward to secure the collar to the stove.
3. Attach your 6" duct, coming from a heat register located a minimum of 17 ft. away, to the starting collar. Secure the duct to the
starting collar with a minimum of three screws.
4. Maintain a minimum of 1" clearance to combustible materials with the entire length of duct.
5. If maximum heat transfer to the duct is desired, replace the air grill, from the front of the stove, with the cover plate from the
kit.
-23-
WARNING!
NEVER DRAW OUTSIDE COMBUSTION AIR FROM:
• WALL, FLOOR OR CEILING CAVITY!
• ENCLOSED SPACE SUCH AS AN ATTIC OR
GARAGE!