Legacy Super Magnum Coal Stoker, Инструкция по установке и эксплуатации

Страница: 22 / 47

Additional Setup
4.0 Mobile Home Setup – USA Only
4.1 OUTSIDE AIR AND SECURING STOVE
•
An outside air inlet must be provided for combustion air,
and must remain clear of leaves, debris, ice, and/or snow.
The outside air path must be unrestricted while the
appliance is in operation.
•
The combustion air intake system must be of metal
construction. It must permit zero-clearance to combustible
materials, and contain a rodent screen.
•
The appliance must be secured to the mobile home structure
by bolting it to the floor. There are brackets included, you'll
need to secure with the proper length lag bolts.
•
The appliance must be grounded to the metal framing of the
mobile home
•
All clearances to combustibles and floor protection
requirements must be followed.
•
Follow the vent manufacturer's instructions when installing
in a mobile home.
•
Installation shall be in accordance with the Manufactured
Home and Safety Standard (HUD) CFR 3280, Part 24
•
The appliance must never be installed in a room designated
for sleeping.
-22-
CAUTION!
MAINTAIN STRUCTURAL INTEGRITY OF MOBILE HOME
FLOOR, WALL, CEILING AND/OR ROOF.
DO NOT CUT THROUGH: FLOOR JOISTS, WALL STUDS,
OR CEILING TRUSSES., OR ANY SUPPORTING MATERIAL
THAT WOULD AFFECT THE STRUCTURAL INTEGRITY.
CAUTION!
NEVER DRAW OUTSIDE COMBUSTION AIR FROM ANY
CLOSED SPACE, SUCH AS:
A WALL, FLOOR OR CEILING CAVITY
AN ENCLOSED SPACE SUCH AS AN ATTIC OR GARAGE
This diagram shows the bracket that was used to bolt the stove
to the pallet. Use at least two of these brackets for securing the
appliance through the floor in a mobile home installation. The
bracket will slip over the top of the leveling adjuster. The
installer will need to determine and obtain the properly sized
lag bolts.
WARNING!
NEVER INSTALL IN A ROOM INTENDED FOR SLEEPING
WARNING!
INSTALLATION MUST COMPLY WITH MANUFACTURED
HOME AND SAFETY STANDARD (HUD) CFR 3280, PART
24