LeCroy HDO6000, Руководство оператора

Страница: 111 / 142

Operator's Manual
Configure Calibration Output
A calibration signal can be output from the Cal Out hook on the front of the oscilloscope. Choose one of
the following under
Use Calibration Output For :
Square - sends a square wave signal. With this selection, also enter the wave Frequency and Amplitude
into 1 MΩ . The Set to 1 kHz, 1 V Square Wave button does exactly that.
DC Level - sends a reference level. Enter an Amplitude into 1 MΩ .
Off - disables calibration output.
Date/Time Settings
Date/Time settings control the oscilloscope's date and timestamp. These numbers appear in the
oscilloscope message bar and on tables/records internal to the oscilloscope application, such as History
Mode and WaveScan.
NOTE : This is not the same as the Timebase reference clock used to synchronize traces.
To access the Date/Time dialog, choose Utilities > Utilities Setup from the menu bar, then touch the
Date/Time tab or button .
Manual Method
Enter the Hour , Minute , Second , Day , Month , and Year , then touch the Validate Changes button.
Internet Method
This method uses the Simple Network Time Protocol (SNTP) to read the time from time-a.nist.gov. The
oscilloscope must be connected to an internet access device through the LAN (Ethernet) port on your
instrument's I/O panel. .
If your connection is active, touch the Set from Internet button.
Windows Method
To set date and time using the internal Windows system clock, touch the Windows Date/Time button.
This displays the standard Windows DateTime Properties pop-up dialog, where you can further configure
these settings. If you are satisfied with the setup, just touch OK.
922499 Rev B
103