Leader Evaporator Springtech EXTREME 6, Руководство пользователя

Страница: 36 / 58

Leader Evaporator Springtech EXTREME 6 Reverse Osmosis System Manual Page: 36
2. Add the chemical required for the type of wash to be performed. NOTE: Ensure the wash tank is filled first.
3. Press the START button on the control panel. Within 30 seconds all pumps should start.
4. If the system does not continue to run due to a LOW PRESSURE ALARM;
c. Light is SOLID ‐ Repeat Step 2 up to 2 additional times. The STOP ALARM RESET button will need to be
pressed after each time.
d. Light is BLINKING – Press the STOP button to reset the alarm. Check the prefilters, changing as
necessary. Repeat Step 2.
5. If the system does not start on the third try, bleed the system. To bleed the system, open the valve on the top
of the strainer (installed before valve V6) until all the air is released from the system. Close the bleed valve.
6. If the system does not start due to a LOW PRESSURE ALARM) partially close valve V18 until an operating
pressure of 50 – 80psi is reached and run the remainder of the cycle.
7. Press the STOP ALARM RESET button to reset the alarm.
8. For an alkaline soap wash ‐ run the Wash cycle until the system shuts down automatically. The system
shutdown is based on the temperature of the liquid. When the liquid reaches 118°F the system will shut
down.
9. Open valve WD to drain the wash tank. When the wash tank has drained, return valve WD to the recirculation
position.
10. Run a rinse cycle (see page 31) using a minimum of 1800 US gallons of permeate in the permeate storage tank.
11. Do a permeability test (see page 22). If the test is good, continue the rinse cycle with any additional permeate.
V3 – Vertical Up
V4 – Horizontal Left
V18 – Vertical Down
V19 – Horizontal Right
V6 – The flow indicator should be toward the wash tank
(handle horizontal left).