Lavit LB115 Series, Руководство по устранению неисправностей

Страница: 41 / 43

SET CO2 PRESSURE
1.
Set the CO2 regulator to 50 psi or (3.5 Bar)
2.
Align the arrow to the beginning of the wide RED bar on the knob
3.
OnceCO2is turned on, CO2CylinderIcon willchange from redtoblack
4.
Purge air from the system from the rear purge valve. (3) one second pulses
NOTE: ITTAKESAPPROXIMATELYTWO HOURS FOR THE SYSTEMTOCHILL DOWN TO THE
PROPER TEMPRETURE
SET UP DATE AND TIME
1.
Select the gear icon from the home screen
2.
Set the date and time
3.
Hitthe back arrow to returntothemainscreen
BLEED AIR FROM LINES
1.
Press the Lavit button to clear the still water line
2.
Select Water
Only – Medium Soda Water
to clear the
soda water line
CALIBRATION
Proper Beverage Volume is critical to create great tasting
beverages.
1. Select the Gearicon
2. Select Service Set Up shown above in Set date picture
3.Enter Password 8888 – Enter to display the SERVICE
MENU
4.on next screen Select Water Set Up
CALIBRATION continued
There are three water streams in a Lavit Cooler:
1. Still Water – pumped from cold tank
2. Mix Stream – Using an ECO Cap start mix stream for 2- second then
stop. Dump water from your measuring then start mix stream
calibration again stopping it at 12OZ. The Mix stream uses external
inlet water to create the beverage mixture
3. Soda Water – from soda tank using CO2 pressure
Calibrate the three water streams: Still, Mix and Soda.
1.
Using a measuring cup press “Start” to begin flowand
“Stop” to end flow when 12 ounces is dispensed
2.
Do this for each stream
3.
After calibration, verify 1
2
oz volume by creating a new
Still and Carbonated Beverage
7
10