Laurell Technologies
Operations Manual WS-400 Lite Series
All information contained in this manual is the property of Laurell Technologies Corporation® and is NOT to be edited, reproduced or
distributed without express written permission from a corporate officer.
40
3.4.2 LINE TWO OF LCD DISPLAY
The second line of the display is used as a heading
for information displayed on the
third and fourth lines. The headings are
min:sec
for the time of each step, and
rpm
for
spin speed in revolutions per minute. Additionally, error messages or conditions will be
displayed at the end of this line. An error example would be when the spin processor’s
lid is left open - the message
LID
will
flash
here (See Figure 3-8)
Figure 3-8
FLASHING LID DISPLAY
3.4.3 LINE THREE OF LCD DISPLAY- SET POINT VALUES
The third line of the LCD display indicates the “set” data programmed for TIME and
RPM for each step in a program. (See Figure 3-9)
•
S
-
used to indicate set point values.
•
min:sec
- displays the set point time in minutes and seconds for each step in a
program. The time resolution for each step is 0.1 seconds. The maximum value
that can be displayed is 99:59.9.
•
rpm
- display shows the set point RPM for each step in a program.
•
valv
- display shows valves which are enabled (optional – may show 4 or 8
valves)
Figure 3-9
SET POINT VALUES
min:sec
rpm
Error
S
